Product Overview
The F12iS uses ATI smart sensors that allow easy interchangeability. Each sensor contains signal conditioning electronics and data memory. Sensors can be calibrated using a spare unit in the shop to avoid using calibration gases in the plant. Sensors may also be returned to ATI for factory calibration, which is useful for gases that are costly or difficult to obtain. Each sensor adjustment (zero or span) is stored in sensor memory and can be reviewed on the F12iS display. This data is very useful in
assessing the sensor’s condition and estimating remaining sensor life.
assessing the sensor’s condition and estimating remaining sensor life.
This sensor comes pre-calibrated and can be used to easily replace other sensors. The ATI Smart Sensors are compatible with the D16, F12 and D-12 monitors.
Features
- Easy to Replace
- Comes pre-calibrated
- Range: 0-20ppm
| More Information | |
|---|---|
| Weight | 1.0000 |
| Warranty | 1 Years |
| Detection Method | Electrochemical |
| Accuracy | +/- 5% |
| Resolution | 0.01 ppm (10 ppb) |
| Supporting Documents | Calibration sheet included |
Warranty Information
Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 12 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered.
Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.