Flow Meter Stainless Ozone Compatible - 6"

• Millimeter scales indicate the vertical position of the spherical float within the metering tube as the flow increases or decreases.
• It is necessary to use flow tables or graphs supplied, to correlate float referenced readings with actual volumetric flow rates.
• The advantage of Universal type scales is the ability to utilize the use of a given flow meter for a great number of different fluids at diverse pressure and temperature conditions, generally preferred in applications in laboratories, etc.
  
  

BUILT-IN VALVES

• Meters are available with built-in needle valves (CV™), high precision metering valves (MFV™) with “non-rising stems”, or with no valves. The higher cost of MFV™ valves is justified whenever high sensitivity control and resolution are desirable particularly in conjunction with metering tubes of very low flowrates.
• Generally, for gas metering it is recommended that valves are positioned at inlets (bottom) for liquids valves may be positioned either at inlets or outlets (top). For vacuum services, valves must be mounted at outlets. If unspecified at the time of ordering, meters will be shipped with valves mounted at the inlets.
  
  

SPECIFICATIONS

STANDARD ACCURACY ±2% FS (mm scales - except 032/042 flow tubes); ±5% FS (direct reading scales and 032/042 flow tubes)

DIMENSIONS 11 x 1.5 x 3.5-in (HxWxD) 28 x 4 x 9-cm - Weight: 1.5-lb (680-g)

CALIBRATED ACCURACY ±1% FS

REPEATABILITY ±0.25% FS

USEFUL FLOW RANGE 10:1 minimum with one float and better than 20:1 with combination of two floats installed in meters

MAXIMUM OPERATING PRESSURE 200 psig (13.8 bars)

MAXIMUM OPERATING TEMPERATURE 250°F (121°C)

MATERIALS OF CONSTRUCTION

FLOW TUBES heavy walled borosilicate glass

FLOATS glass, sapphire, 316 stainless steel, carboloy and tantalum

SIDE PANELS aluminum, black anodized

FRONT SHIELD Lexan® with longitudinal magnifier lens for enhanced reading resolution

BACK PLATE 1/8 inch thick white acrylics

O-RING and PACKING Buna-n o-rings standard in aluminum and brass models; Viton® o-rings standard in stainless steel models; optional Viton®, PTFE/Kalrez®, EPR

CONNECTIONS 1/8 inch NPT female inlet and outlet connections; optional 1/4 inch FNPT, hose and compression fittings are available

VITON® and KALREZ® are registered trademarks of DuPont Dow Elastomers

NIST - National Institute of Standards

Technical Information

Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 12 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.