This simple, low cost, air-drying canister kit is the answer to your moisture laden ambient feed-gas issue.Place this before your ozone generator to ensure consistent ambient feed gas quality. This product can be used with the HP-200, HP-500 (if you want a larger capacity air drier) AC-500 models excluding the AC-500G, OZV-4 & 8, HG-1500, & UV analyzers.
What makes the AD-500 different
The AD-500 and MI-1 kit is a more affordable option when needing an air drier, as compared to our MAG-600 and MI-1 kit. The difference between the two products is that the media must be removed from the shell of the AD-500 to dry it. Because of this, the AD-500 features a large removable threaded cap to make it an easy process.
Large removable threaded cap
Includes 1 ft. of FEP tubing (1/4 x 3/8 inch)
Desiccant can be dried and/or replaced when fouled
Includes a MI-1 moisture indicator
1/4-inch brass barb fittings (inlet & outlet)
2.0 lbs (0.91 kg)
120 - 240 VAC 60 Hz
Length: 13 in (33 cm) Diameter: 3.3 in (8.3 cm) (13 inches includes the fittings)
1 Year, (This excludes the normal maintenance of drying or replacing the desiccant media).
32 to 90°F (0.0 to 32.22°C)
Air Dryer Type
Desiccant - Heat Regenerative
Air Dew Point
Max Flow Rate (LPM)
Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 12 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.
California Regulatory Warning
All of Ozone Solutions ozone generators are intended for industrial use ONLY.
Use in unoccupied spaces only.
Health hazard warning: emits ozone.
This product is not CARB Certified (Ozone Emissions for Air Cleaners).
Product Disclaimer: Does not meet California air cleaner regulation requirements; cannot be shipped to California.