The F12 is a wall-mounted ozone monitor and controller, built with a NEMA 4X enclosure capable of handling harsh situations. It is an incredibly configurable device, allowing for ideal use in many situations.
The two major benefits of the F12 are its rugged design, and easy maintenance. The enclosure will stand up to environments where dust or moisture may pose problems, and when the time comes for sensor replacement, you can merely swap in a new sensor - there is no need to remove the whole device and send it in for calibration. These are the same sensor modules that the C16 Portable Ozone Detector uses - making the two a convenient pair in applications requiring both fixed-mount and portable ozone detection equipment.
Our standard configuration (available for purchase here) comes equipped with 3 programmable relays for alarm or control, 4-20 mA output, and an LCD display. See the Specifications and Options listed below for further details. [b]Monitor Quick Comparison:[/b] Portable: No Range: Multiple Display: LCD Alarm: Yes Outputs: Multiple Datalogging: No Indoor/Outdoor: Indoor & Outdoor
Optional Accessories
Description
Calibration Kit
Use the A14-A11 Calibration Kit to calibrate your ozone sensor
Auto Test Generator
Verify sensor operation by providing a "bump test" of the sensor from daily to once a week
DL-2 Data Logger
Record ozone levels over a period of time and transfer the data to your computer
SL-1 Ozone Indicator
Indicator light that can be used to alert of high ozone levels. Compatible with many of our popular ozone monitor models.
Remote Sensor
Remote Interconnect Cable, specify length, max. 50 ft
Ozone Sensors Avalaible
Range
Ultra Low
0-.5 PPM
Low
0-2 PPM
High
0-20 PPM
Extra High
0-1000 PPM
Features
NEMA 4X Polycarbonate Enclosure
Pre-calibrated, Field-Replaceable sensors for easy maintenance
Sensor Auto-Test Option available
Can utilize sensor modules for other ranges and gases
User Manual and NIST Traceable Calibration Sheet included
Alarm
Relays Three relay options: SPST, 5 A @ 230 VAC resistive
Has Battery
No
Humidity Range
0 to 95%
Internal Datalogging
No
Display Units
Dependent on sensor
Comm. Protocol
None
Relays
3
F12 Specifications
F12 Information
Warranty Information
Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 12 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.
California Regulatory Warning
All of Ozone Solutions ozone generators are intended for industrial use ONLY.
Use in unoccupied spaces only.
Health hazard warning: emits ozone.
This product is not CARB Certified (Ozone Emissions for Air Cleaners).
Product Disclaimer: Does not meet California air cleaner regulation requirements; cannot be shipped to California.
