The ODS-3H Ozone Destuct Unit will safely convert ozone gas into oxygen, with 99.9% efficiency. Catalytic destruct media is used to efficiently convert ozone to oxygen with no by-product or consumables.
A heater band is used in conjunction with piping configurations, in order to keep water vapors from condensing on the destruct media. The ODS-3H must be mounted in the upright position to maintain efficient operation and moisture removal. For very wet air (contact tank off-gas), we recommend using a water trap with the ODS-3H to remove bulk moisture.
3-SCFM Flow-rate Capacity
3/4-inch Female NPT Inlet and Outlet
All Stainless Steel Construction
Integrated heater band
24 watt power consumption
120 VAC 60 Hz 25 watts
Length: 13 in (33 cm) Diameter: 6.5 in (16.5 cm)
0.0 to 0.25 PSI (0.0 to 0.02 Bar)
0 to 100%
Wet/Humid gas stream
Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 12 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.