These fine-pore diffusers are used specifically for ozone applications. They come in several sizes to accommodate your reaction vessel & flowrate. Glass-bonded diffusers & Kynar (or SS) material ensure long life in ozone rich environments.
Completely ozone resistant
Resistant to clogging
Easily cleaned with HCl
0.72 lbs (0.33 kg)
1.5" x 1.5" x 3" (3.8 x 3.8 x 7.62 cm)
Max Pore Size
Stainless Steel, Glass-Bonded Silica
Flow Rate LPM
10 LPM (MAX)
How do I clean the diffuser?
The only maintenance normally required is periodic cleaning. (1) Remove from service and blow off excess water, clean off any foreign material. (2) Immerse completely in undiluted muriatic acid for a sufficient time to dissolve the clogging material. This may take from one minute to eight hours in extreme cases. Please take all necessary precautions when working with acid. (3) After clogging material has been dissolved, rinse thoroughly before reuse. (4) Discard the used acid by first reducing its strength to a neutral pH, diluting with at least 10 times as much water as acid.
How do I size a diffuser for my application?
We suggest sizing the diffuser based upon the gas flow rate going into it. The suggested flow for each diffuser is listed on the chart under "Suggested Flow". LPM = Liters Per Minute
Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 6 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.
California Regulatory Warning
All of Ozone Solutions ozone generators are intended for industrial use ONLY.
Use in unoccupied spaces only.
Health hazard warning: emits ozone.
This product is not CARB Certified (Ozone Emissions for Air Cleaners).
Product Disclaimer: Does not meet California air cleaner regulation requirements; cannot be shipped to California.