This diaphragm valve is a 2-way, internally piloted, normally closed solenoid valve. This diaphragm valve allows for higher flow rates for oxygen and ozone. The internal oriface size is 9/16" allowing for a 2.8 CV factor.
The SVSS-6D uses an internally piloted diaphragm to open and close the valve. All our ozone ozone resistant valves use a direct seat. This diaphragm allows for higher flow rates, and less chance of obstruction.
3/8-inch NPT connections - 2.8 CV Factor
Diaphragm valve for high flow applications
Viton seal with Stainless Steel construction
Viton offers a positive seal, and great reliability
Easy to rebuild, no special tools required
2.0 lbs (0.91 kg)
110 - 120 VAC 50/60 Hz
3.6 x 2 x 2.9 inches (9.2 x 5.1 x 7.4 cm)
200 PSI (14.06 Bar)
Stainless Steel, 316L stainless steel
Minimum Operating Pressure
0.0 PSI (0.0 Bar)
Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 6 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.