Ozone Calibration Source - A23-14

ATI’s A23-14 Ozone Generator is a portable generator designed to produce an ozone gas concentration below 1 PPM, which can be used for detector calibration at almost any location. The generator uses a compressed air cylinder to supply dry air to an ultraviolet cell where ozone gas is formed. The resulting flow of air with a small amount of ozone exits the generator cell through fluorocarbon outlet tubing that is used to deliver the ozone standard to a gas sensor such as the Q45/65 Dissolved Ozone Monitor.

Operation of the ozone gas generator is very simple. The UV generator cell is plugged into any convenient power outlet and the valve on the air cylinder is opened. The cylinder valve is a fixed flow regulator so that no flow control is required. The outlet tubing from the generator is connected to your ozone gas sensor for whatever period is needed for calibration and then the system is shut off. Ozone generator output is nominally around 0.8 PPM, but each generator is individually marked with an accurate ozone gas concentration value measured prior to shipment.

Ozone generators are supplied in a durable molded case with sufficient space for outlet tubing and calibration adapters. The basic kit contains the generator, one 103 liter air cylinder with fixed flow regulator, and 3 feet of outlet tubing.

Review the manual here.

• Simple Operation
• Supplied with durable molded case
• Supplies stable ozone concentration of .8 PPM

More Information
Weight	15.0000
Electrical	110 - 120 VAC 60 Hz
Dimensions	4 x 8 x 23 inches (10.2 x 20.3 x 58.4 cm)
Warranty	1 Years
Accuracy	+/- 20%

A23-14 Product Specifications	A23-14 Manual

Seller warrants that all Products will conform to the Specifications and will be free from defects in material workmanship and programming. Claims for Products not complying with this warranty shall be submitted by Buyer no later than 12 months from delivery date to Buyer. Seller shall promptly repair or replace, at its option and expense, non-complying Products. The shipment of non-complying Products by Buyer to Seller, and the return shipment of repaired or replacement Products by Seller to Buyer shall be at Seller's expense, unless it shall be determined that Buyer returned a Product that was in compliance, in which case such cost shall be borne by Buyer and, if paid by Seller, these expenses shall be reimbursed by Buyer within thirty (30) days of notice by Seller. Buyer shall receive a credit for any non-complying Products returned for repair or replacement. All non-complying Products shall be returned to Seller (at its offices or as otherwise instructed) no later than 30 days as of the date the non-compliance of any such Product has been discovered. Seller is NOT responsible for any/all damages suffered to the Products that is caused by the Buyer. Such as but not limited to damage by wrong electrical current, damage through crush or dropping the product, damage through untrained users of Product, damage through improper operations.